Page History
...
- Start a "Terminal" from the Applications/Activities menu, execute the command "ifa systemctl stop docker" and wait for the command to finish (this may take several minutes).
- Start the "LVM Manager" (Logical Volumes Manager) from the Applications/Activities menu and select the volume group "cl-pan" on the left hand navigation bar.
- Select the "pgdata" volume, right-click it and execute "Unmount"
- The unmount process will reset the selection in the device list, so please select "pgadata" again.
Tip: volumes can also be selected via the top navigation bar:
- Right-click "pgdata", go to the edit sub-menu and select "Resize"
- Drag the indicator to the right to add disk space to this volume and confirm with "Resize"
Note: even though were are adding all disk space to one volume in this example, the new available disk space may be divided between multiple volumes. For more information on calculating disk space requirements, please refer to the Setup Guide. - Apply the changes using the check-mark symbol (Apply pending actions) in the top tool bar
- After confirming the queue, you should see a success message like the one below and the new disk space will now be available to iDNA.
- Depending on the size of the environment, the "appdata" partition may have to be resized as well. If that should be the case, please repeat the actions in steps 3 to 8 for this partition as well.
A likely reason for the "appdata" partition needing resizing as well is if you have a large environment with a lot of applications. Please see the Virtual Hardware section in System Requirements for partition sizing recommendations. - To complete the changes, we need to start iDNA Applications again. Since one or more partitions might be unmounted at this point, the easiest way to do this is execute the command "reboot" in the command line.